METALTERJ #288
Industrial Detergent With Booster Solvent

A cost-efficient detergent for removing detergent-resistant substances from both ferrous and non-ferrous metals. The detergent-solvent combination removes many carbonaceous and resinous substances that are difficult or impossible to remove with detergents only.

Prevents in-wash rust, retards after-wash rust, but, especially if rinsed, the use of a suitable rust inhibitor is recommended for assured rust prevention. Use at any temperature; but many detergent-resistant substances can be removed only at temperatures over 120F. Has low, unstable foam at any temperature. Typical uses....

Parts Cleaning or Cleaning & Deburring		Equipment Cleaning
-in-		-such as- Machinery - Heat Exchangers -by-
Spray Washers	Spindle Machines
Soak Tanks	Agitated Tanks
Vibrators	Electrolytic Tanks	Steam Cleaning or Pressure Washing
Tumblers	Ultrasonic Tanks	Recirculation or Soak or Boil-Out

Performance Properties & Active Components

Dissolves instantly in hot or cold water; low viscosity assures consistently accurate solutions when fed thru a metering pump or suction device such as a venturi injector.

At recommended use dilutions, it provides:

• Quick wetting, penetration, dispersion, suspension, and solution of solids and oily substances,
• Very low foam at any temperature,
• Prevention of in-wash rust, retardation of after-wash rust,
• Quick, virtually spot-free rinsing, if desired, and scale-free equipment -- both due to low surface tension and deactivation of calcium and other hard water ions.

Contains buffered alkali, organic chelant and sequestrant, organic rust preventative, organic solvent, anionic wetting agent, penetrant and dispersant. Does NOT contain nitrites, chromates or phosphates.

Recommended Use Dilutions

Dilute in water to suit the job. The dilution required depends on the quantity and type of dirt, porosity of the surface, temperature, soak time allowed, and degree of agitation applied by the cleaning method used.

To remove oils, lubricants, rust inhibitors, vegetable oils, waxes and similar substances: at least..........1% Sol = 1.3 oz/gal.

To remove detergent-resistant substances such as some resins, marking inks, drawing compounds, asphalts, special lubricants: usually no more than............ 10% Sol = 12.8 oz/gal.

For any unusually severe conditions: as needed up to.......Full-strength product.

Use Temperatures & Time Required

Hot solutions, 140F to boil point, provide the most effective cleaning. “Cold” solutions, at ambient temperatures, remove many common industrial substances such as oils, rust inhibitors and buffing compounds; when used cold, higher concentrations and longer time may be needed.

For some substances, especially if they are solids or very thick at ambient temperatures, hot solutions are essential.

One to 15 minutes is normally required for parts. The time required for equipment varies greatly; some substances are removed instantly on contact, others need hours.

Properties - DOT Class - Precautions